Configuring computer
This section describes setting up communications using a terminal emulator program. The terminal emulators built into many Campbell Scientific software products, such as LoggerNet, can also be used.
The following settings should then be used by default:
Bits per second: 38400
Data bits: 8
Parity: none
Stop bits: 1 Flow control: none
After adjusting the baud rate of the unit, use the terminal emulator to adjust the bits per second value in the port settings. The CS120A/CS125 can not communicate with the computer if the unit and port setting baud rates differ.
The CS120A/CS125 should now be ready to accept commands.
The CS120A/CS125 can be set to the default communication state using an internal switch on the sensor main board (see Internal switches).