Loading a new operating system (OS)
A new OS can be entered with the LOADOS command.
The new OS must be sent using xmodem protocol using Tera Term. See Terminal mode commands general.
To load a new operating system:
Enter terminal mode by typing Open 0 (for a sensor with the default ID 0)
This will return the prompt: CS136>
Type the command: LOADOS
The SkyVue 8 will respond:
Load OS into DSP
DO NOT REMOVE POWER DURING OS UPDATE!!!
Waiting for xmodem
At this point, use your terminal emulator to send the appropriate file. Loading the OS could take a few minutes.
When the process is complete the SkyVue 8 will return the message:
Updating DSP OS, please wait....PASS
Updating TOP OS, please wait....PASS
Updating PSU OS, please wait....PASS
Wait 40 sec for OS to restart
Afterwards, the SkyVue 8 will resume operation according to the previously set operating parameters. It will no longer be in terminal mode.