Server Data Source Properties

Source Name

Designates the name that will be used for the communications server in the Data Source Browser and on the status bar.

Server Address

This is the hostname or TCP/IP address of the computer running the communications server. This must be the valid name of an existing computer or a TCP/IP address in the form XXX.XXX.XXX.XXX for an IPv4 address or [XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX] for an IPv6 address.  If the communications server resides on the same computer as RTMC, you can simply type in LocalHost for the server address. By default, LoggerNet's port number is 6789. If this default port number is used, it does not need to be specified in RTMC Pro. Otherwise, it is specified after Server Address, separated by a colon. An example would be 192.168.4.32:3000, where 3000 is LoggerNet's port number.

Username

 Your username on the communications server.

Password

Your password for the communications server.

The Username and Password fields are required only if your server administrator has enabled security on your system.

You can save the login information by selecting the Remember username and password check box.

NOTE: When running RTMC from RTDAQ, the server connection is always to LocalHost. You cannot change the server address.

NOTE: If LoggerNet Security is enabled and your project will be published to the Web using CSI Web Server, you must select the Remember username and password checkbox. You will not be prompted for the LoggerNet Security password when viewing your project from the web.  Therefore, if the username and password have not been saved with the project, you will not be able to perform any functions that require the username and password.