Predefined Constants

The datalogger operating systems have a list of reserved words called predefined constants that are used internally. These reserved words cannot be used as variable or table names in a program. The predefined constants include some instruction names, as well as valid alphanumeric names for instruction parameters. In general, instruction names should not be used as variable, constant, or table names in a datalogger program, even if they are not specifically listed as a predefined constant. In addition, constants used in Data Table Access syntax are reserved and should not be used as variable, constant, or table names.

Following is a list of predefined constants:

_50 _50hz _60 _60hz _Fast _Medium _Slow Auto Autoc AutoRange AutoRangec BOOL8 BOOLEAN C1 C2 CAO1 CAO2 Case Com1 (numeric code 9) Com2  (numeric code 10) Com3  (numeric code 11) Com310  (numeric code 3) Com320 (numeric code 6) Com4  (numeric code 12) ComC1_TX ComC1_RX ComC2_TX ComC2-RX ComME (numeric code 2) ComRS232 (numeric code 1) ComRS232_RX ComRS232_TX ComSDC10 (numeric code 7) ComSDC11 (numeric code 8) ComSDC7 (numeric code 4) ComSDC8 (numeric code 5) ComUSB CR1000 CR1000X CR300 CR3000 CR350 CR5000 CR6 CR800  CR9000X CURRENT408 day DO DOUBLE EVENT EX1 EX2 EX3 FALSE FLOAT FOR GRANITE6 GRANITE9 GRANITE10 hr IEEE4 If IX1 IX2 IX3 IX4 LoggerType LONG min mon msec mv1000 mv1000C mv1000cR mv1000R mv2_5 mv2_5c mv20 mv200 mv200c mv200cR mv200R mv20c

mv25 mv250 mv2500 mv2500c mv250c mv25c mv34 mv50 mv500 mv5000 mv5000 mv5000c mv5000C mv5000cR mv5000R mv500c mv50c mv50c mv50cR mv50R mv7_5 mv7_5c mvX10500 mvX1500 NSEC  OSVersion P_LL P_SW P_VX_1 P_VX_2 PROG SCAN SE1 SE2 SE3 sec Select StationNameSetting STRING SUB SUBSCAN SW12 SW12_1 SW12_2 TABLE TEMP408J TEMP408K TEMP408T TIMPUData TRUE TypeB TypeE TypeJ TypeK TypeN TypeR TypeS TypeT UINT1 UINT2 UINT4 Until usec v10 v2 v20 v2c v50 v60 VOLT408V1 VOLT408V10 VOLT408V60 VX VX1 vX105 vX15 VX2 VX3 VX4 While X1 X2 X3 X4

The list of predefined constants is also available from the datalogger terminal mode (from Device Configuration Utility Configuration tool used to set up dataloggers and peripherals, and to configure PakBus settings before those devices are deployed in the field and/or added to networks., click the Terminal tab) using command "F" and then "C".